START-UP AND OPERATION INSTRUCTIONS
ECOMINI
Rev. 000
18/09/2017
27/37
4.7.8 BRUSH ADJUSTMENT
To adjust the brush (only version without rotation) proceed as follows:
remove the key from the control board to prevent accidental ignition;
prepare the necessary tools;
anti-clockwise rotate the eccentric bushings;
turn the machine on and advance to check if the scrubber proceeds straight without jumping: if this
does not happen repeat the adjustment.
For the machine with
rotating squeegee
, there must be no intervention by the operator. The above
mentioned bushings must stay in the position shown in figure 4.16 detail 1.
The machine can dry both forward and backward, therefore the brush must be perfectly parallel to the floor.
FIGURA N° 4.16
FIGURA N° 4.16
1
