Finn HydroSeeder TITAN280, Инструкция оператора и каталог запасных частей

Страница: 39 / 87

33
5. Check antifreeze in radiator. Add antifreeze as required.
6. Inspect the slurry tank for buildup of residue in the suction area and clear if necessary.
7. Check and clean engine radiator. Flush with clear, low-pressure waterspray and blow dry with
compressed air. Do NOT use high-pressure water spray.
8. Check pivoting hose reel swivel bolt. Ensure proper torque. Replace bolts if any show signs of
wear.
9.
Check oil level in agitator gear boxes. Refer to Maintenance Chart.
SEASONAL AND WINTER STORAGE MAINTENANCE:
1. Drain the slurry tank of all water, prior to storage, and leave the drain plug uninstalled.
2. If possible, cover machine with tarp or park inside of an enclosure.
3. Store the HydroSeeder
®
with all slurry valve handles in the open position. To prevent damage
from freezing, it is advisable to remove all slurry valves and store in a heated area.
4. Pour 1 qt (0.95 L) of mineral oil or environmentally safe lubricant into the pump housing and
spin pump by hand to prevent rust in the pump. Remove drain plug.
5. Chip and steel-brush any interior rust spots in the slurry-tank and touch up with paint. See num-
bers 2 and 3 in IV. MAINTENANCE of the HYDROSEEDER® SAFETY SUMMARY SECTION
on page 4.
6. Lubricate all fittings.
7. Check antifreeze in radiator. Add antifreeze as required.
8. Lubricate equipment again just prior to putting into operation after having been in storage.
10. Change hydraulic oil and filter. (500 hours)
11. Disconnect battery cables. In cold weather, remove battery and store it in a safe, warm place.
12. Add fuel stabilizer to fuel tank.