Finn HydroSeeder TITAN280, Инструкция оператора и каталог запасных частей

Страница: 18 / 87

12
AMBER
WARNING LED
RED SHUTDOWN
DERATE LED
DISPLAY
BEZEL
MENU KEY ENTER KEY
LEFT
ARROW KEY
(Scroll Up)
RIGHT
ARROW KEY
(Scroll Down)
STARTING PROCEDURE
CAUTION
See HYDROSEEDER® SAFETY SUMMARY SECTION on pages 2 through 5 before operating the
machine. Failure to comply could result in mild to moderate personal injury. Failure to comply
could also result in product or property damage.
Before starting, open recirculation valve, close discharge and remote valves (if applicable), disengage
(turn off) clutch, and place agitator control in the NEUTRAL position.
1. Turn the key clockwise until the starter engages and the engine starts.
2. Allow engine to warm up for 3 to 5 minutes.
NOTE.
This engine has a safety system that will shut the engine off if the en-
gine oil pressure drops below 7 psi (48 kPa) or if the water temperature
reaches 230˚F (110˚C).
POWERVIEW
The PowerView is a multifunctional tool that enables the operator to view many different engine pa-
rameters and service codes. A graphical back-lit LCD screen can display either a single parameter,
or a quadrant display showing four parameters simultaneously. Diagnostic capabilities include fault
codes with text translation for the most common fault conditions. The following relative engine param-
eters can be displayed in either English or Metric units, as well as in Spanish, French, or German:
• Engine rpm
• Engine Hours
• System Voltage
• % Engine Load at Current rpm
• Coolant Temperature
• Oil Pressure
• Throttle Position
• Active Service Codes
Figure 9
–
Faceplate Features
Engine Throttle
(optional)
Pump Control
Used to engage
Disengage the pump
Horn
Key
Switch
Emergency
Stop
Murphy View
Used for general
engine
data and warnings
Figure 8