Finn HydroSeeder T170, Руководство по эксплуатации и каталог запасных частей

Страница: 8 / 77

HYDROSEEDER
®
SAFETY SUMMARY SECTION
It is important that all operators of this machine are familiar with all safety aspects covered in this section and
have read the entire Operator’s Manual before operating the machine. Always keep a copy of this manual with
the machine. It is the responsibility of the operator of the machine to fully understand this safety summary sec-
tion. Remember that YOU are the key to safety. Good safety practices protect not only you but also the people
working with and around you. Keep in mind that this safety section is written for this type of machine only.
Practice all other usual and customary safe working precautions. Above all, remember that safety is up to you.
The FINN HydroSeeder® is designed to mix and apply water, seed, fertilizer, agricultural lime, and hydraulic
mulch to the prepared seedbed. The resultant slurry from mixing one or more of the above materials may react,
causing harmful or deadly gasses within the tank. Heat, evaporation, or extended emptying period can/will
accelerate the formation of these gasses. Please contact your supplier(s) of these slurry components regarding
their potential reactivity.
I. PRE-START EQUIPMENT CHECK (equipment
check is to be made with the engine off):
1. If you have a chassis-mount-
ed unit, check devices secur-
ing HydroSeeder® to the
truck or trailer frame.
2. If HydroSeeder® is a trailer unit, check hitch and hitch
bolts, lights, brakes, and all safety components.
3. Make sure loading hatch bag cutter is in place and
secure.
4. Check that all guard railing is in place and secure.
5. Verify that all guards are in place.
6. With the ignition switch ON, verify that the signal horn
is operating correctly.
7. By carefully looking down through the loading hatch,
inspect the slurry tank for foreign objects. Never enter
the tank without following the procedures described in
step 3 of IV. MAINTENANCE on page 4.
8. Remove unnecessary objects (or material) from the
tank top.
9. Make sure no one is working on or inside the machine.
Give a visual and audible signal that all is clear, before
starting the engine.
10. Inspect all hydraulic hoses for cracks, bulges, or dam-
age. If hoses are bad, replace immediately.
11. Inspect all discharge hoses for cracks, bulges, or dam-
age. If hoses are bad, replace immediately.
II. MACHINE OPERATION:
1. Always wear safety goggles
when operating the machine.
Other safety attire such
as safety shoes, ear pro-
tection, gloves, hard hats,
dust masks, etc. should be
worn as required by warning
decals on machine, opera-
tor’s manuals, or job site
requirements. Remove rings,
watches, etc. Avoid wearing loose-fitting clothing that
may get caught in rotating machinery.
2. Do not operate the machine
without all guards in place.
3. Do not load unit while in transit. Load only when parked
and unit is as level as possible. Take care not to drop
pens, lighters, etc. or pieces of paper or plastic bags
into the tank as these objects might plug the slurry
system. Should any object be dropped into the tank, do
NOT reach into the tank to retrieve the foreign object.
See step 3 under IV. MAINTENANCE on page 4 before
allowing any personnel to enter the tank.
4. Make sure area to be sprayed is clear of all persons,
animals, etc.
2