Finn HydroSeeder T170, Руководство по эксплуатации и каталог запасных частей

Страница: 31 / 77

25
CLEANING AND MAINTENANCE:
AFTER FIRST 4 TO 8 HOURS OF OPERATION:
1. Check and adjust clutch. See clutch manual.
DAILY:
1. Cleaning the HydroSeeder
®
A. Fill slurry tank to center of agitator shaft with clean water.
B. Move agitator lever to full speed to flush off inside of tank top and walls.
C. Remove discharge nozzle and gasket from discharge boom.
D. While pointing discharge toward an open area, move discharge valve handle to DIS-
CHARGE position and engage (turn on) clutch. Allow to discharge until clear water is
coming out.
E. Move recirculation valve handle to RECIRCULATION and allow to run momentarily.
F. Disengage (turn off) clutch, idle the engine, move valve handle to DISCHARGE posi-
tion, move agitator handle to NEUTRAL, and turn off engine.
G. Always remove drain plug and allow the tank to drain.
H. In freezing weather, leave main tank drain plug out and remove pump drain plug. Move
all slurry valves to OPEN position.
I. Wash the outside of the HydroSeeder
®
, including the radiator, to remove any cor-
rosive materials.
J. If using lime, daily maintenance should be performed after every load.
K. Clean out extension hoses.
L. Make sure all tank vents are clean and open. Do not plug or cap.
2. Lubricating the HydroSeeder
®
– See LUBRICATION AND FLUIDS CHART on pages 26 and
27.
CAUTION
Lubrication should be performed IMMEDIATELY AFTER cleaning of the equipment, making sure
the engine is not running. Failure to comply could result in minor or moderate personal injury.
Failure to comply could also result in product or property damage.
A. Lubricate the agitator shaft bearings located on the outside front and rear of slurry
tank.
B. Service the automatic pressure lubricator on pump as needed. See page 10.
C. Check the engine oil and replenish when necessary. Change oil and filter after first 100
hours, then 250 hours thereafter. Consult the engine operator’s manual for the correct
grade of oil and the engine break-in procedure.
D. Lubricate the swivel on the discharge assembly and the swivel on the hose reel.
E. If equipped with the Air Flush Option, refer to the Air Flush System Manual.