Finn HydroSeeder T170, Руководство по эксплуатации и каталог запасных частей

Страница: 32 / 77

26
WEEKLY OR EVERY 40 HOURS OF OPERATION:
1. Clean the air cleaner following the instructions in the engine operator’s manual.
2. Lubricate all the points on the HydroSeeder
®
as outlined in DAILY on page 24. Additionally,
lubricate the four grease fittings on the clutch/pump.
3. Check the level in the hydraulic oil reservoir; maintain level at sight gauge.
4. Check the clutch adjustment to ensure that it “snaps” in and out of engagement. Adjust the
clutch with the engine off.
5. Check the anti freeze in the radiator.
6. Inspect the slurry tank for build-up of residue in the suction area and clear if necessary.
7. Check and clean engine radiator. Flush with clear, low-pressure water and blow dry with com-
pressed air. Do NOT use high-pressure water spray.
8. Check pivoting hose reel swivel bolt. Ensure proper torque. Replace bolts if any show signs
of wear.
SEASONAL AND WINTER STORAGE MAINTENANCE:
1. Drain the slurry tank of all water, prior to storage, and leave the drain plug uninstalled.
2. If possible, cover machine with tarp or park inside of an enclosure.
3. Store the HydroSeeder
®
with all slurry valve handles in the open position. To prevent damage
from freezing, it is advisable to remove all slurry valves and store in a heated area.
4. Pour 1 qt (0.95 L) of mineral oil or environmentally safe lubricant into the pump housing and
spin pump by hand to prevent rust in the pump. Remove drain plug.
5. Chip and steel brush any interior rust spots in the slurry-tank and touch up with paint. See
Numbers 2 and 3 in IV. MAINTENANCE of the HYDROSEEDER® SAFETY SUMMARY
SECTION on page 4.
6. Lubricate all fittings.
7. Check anti freeze in radiator.
8. Lubricate equipment again just prior to putting into operation after having been in storage.
10. Change hydraulic oil and filter. (500 hours)
11. Disconnect battery cables. In cold weather, remove battery and store it in a safe, warm place.
12. Add fuel stabilizer to fuel tank.
HYDRAULIC SYSTEM:
The hydraulic system on your FINN HydroSeeder® is designed to give trouble-free service,
if maintained as required. The most important areas of maintenance are the hydraulic oil and fil-
tration. The reservoir holds 22 gal (83 L) of Mobil DTE-13M or equivalent hydraulic oil. The
hydraulic oil should be replaced per the lubrication schedule or if the oil becomes milky or gives
off a burnt odor. The hydraulic oil filter must be replaced on schedule with a 25 micron abso-
lute filter (FINN part number 021618). The hydraulic system relief is factory-set at 2,800 psi
(19,305 kPa).