Finn HydroSeeder T170, Руководство по эксплуатации и каталог запасных частей

Страница: 16 / 77

10. Lubricate equipment - See LUBRICATION AND FLUIDS CHART on pages 26 and 27.
A. Each lubrication point is marked.
B. Check automatic pressure lubricator at pump. If the stem is
fully extended, with thumb nut all the way up, then automatic
pressure lubricator contains lubricant. If not, lubricant must be
replaced by the following procedure (See Figure 3):
a) Turn thumb nut clockwise until stem rises to maximum
height.
b) Remove cap and fill cap with sodium-(water soluble) base
grease. (FINN part number 000698). Do not use lithium-
base (chassis lube) grease.
c) Replace cap.
d) Turn thumb nut counterclockwise until the thumb nut is at
the top of the stem. The spring and pressure disc in the lubri-
cator forces the grease, under pressure, to the pump seal.
NOTICE
When the thumb nut has moved down to within 1/2in. (1.25 cm) of touching the cap, re-service
the automatic pressure lubricator.
11. Engage (turn on) and disengage (turn off) clutch to determine if it snaps in and out.
12. Check nozzle for obstructions and clean as required.
13. Check pump discharge and recirculation valve handles for free movement.
14. Make sure all tank vents are clean and open. Do not plug or cap.
TWO-VALVE OPERATION:
This HydroSeeder
®
is equipped with two indepen-
dently operated plug valves to control slurry flow. One
is located in the recirculation line below the platform,
and the other is located in the discharge line above the
platform. The valve handles should be positioned as
shown in Figures 4 through 6 for the particular applica-
tion required.
WARNING
Never engage (turn on) slurry pump clutch when both valve handles are positioned as shown
in Figure 4. Both valves are closed and will result in extreme heat generation. Failure to comply
could result in severe personal injury or death.
10
Figure 3 –
Automatic Pressure
Lubricator
THUMB NUT
STEM
CAP
GREASE
PRESSURE
DISK
SPRING
DISCHARGE VALVE
(SHOWN CLOSED)
RECIRCULATION
VALVE
(SHOWN CLOSED)
TANK
Figure 4 – DO NOT Engage
(Turn On) Clutch