Finn HydroSeeder T170, Руководство по эксплуатации и каталог запасных частей

Страница: 15 / 77

6. Radio Remote Control: The radio remote control option provides the operator with pump ON/
OFF control, throttle control, and engine shutdown at the end of the hose. With control of the
engine throttle, the operator can precisely adjust the pump flow to whatever output the situ-
ation requires (such as close-up work around buildings). The ability to remotely shut off the
pump allows the operator to close the recirculation valve for increased performance during
hose work. Carrying the remote valve at the end of the hose becomes unnecessary.
NOTE:
For remote pump ON/OFF control, the clutch cylinder must be con-
nected to an air supply.
7. Air Flush System: The air flush option uses compressed air to purge any remaining mulch slur-
ry from the HydroSeeder® hose, the discharge boom, and the recirculation piping. To maximize
performance, all discharge plumbing should be purged after every load. The air flush system
provides a quick and easy means of purging without the need to acquire a flush tank and an
additional water supply.
PRE-START CHECK:
Safety check to ensure operator safety:
1. Check condition of all mounting hardware that secures HydroSeeder
®
to truck frame.
2. Make sure bag cutter is in place and secure.
3. Inspect all railings, ensuring they are all in place and secure.
4. Make sure that all guards are in place.
5. With the ignition switch on, verify that the amber safety light, under the operator’s plat-
form, is flashing.
EQUIPMENT CHECK:
WARNING
Equipment check should be made with the engine off and all rotating parts stopped. Failure to
comply could result in severe personal injury or death.
1. Make sure that tool kit contains all the prescribed items. See TOOL KIT on page 71.
2. Inspect the slurry tank for foreign objects. See numbers 2 and 3 in IV. MAINTENANCE of the
HYDROSEEDER® SAFETY SUMMARY SECTION on page 4.
3. Check fuel level and fill if necessary.
4. Check the hydraulic oil level and fill to proper level if necessary. See HYDRAULIC SYSTEM
on page 26 for oil specifications.
5. Check engine oil level and fill to proper level if necessary. For oil type refer to the engine
manual.
6. Check fluid level in radiator and fill to proper level if necessary.
7. Inspect air cleaner for dust and dirt; clean if necessary.
8. Secure the drain plug on the outside bottom of the slurry tank.
9. Check to be certain pump drain plug is in place.
9