Fimap MAGNA PLUS, Руководство по эксплуатации и обслуживанию

Страница: 43 / 48

TROUBLESHOOTING
This chapter lists the most common problems linked with the use of the machine. If you are unable to resolve the problems with the information
given here, please contact your nearest assistance centre.
PROBLEM POSSIBLE CAUSE SOLUTION
THE MACHINE
DOES NOT START
The main switch is set to “0”.
Make sure that the main switch is in its "I" position, otherwise turn the key a
quarter turn clockwise.
Check that when switched on there
are no alarm messages on the
command display.
Stop the machine immediately, and contact a specialised service centre.
Make sure that the batteries are
correctly connected to each other
and that the battery connector is
connected to the electrical system
connector.
Correctly connect the batteries inside the machine.
Check the charge level of the
batteries.
If the battery charge level is critical, perform a complete recharge cycle (see
paragraph CHARGING THE BATTERIES ”).
THE BATTERIES
ARE NOT CHARGED
CORRECTLY
The connector of the battery charger
cable is not properly inserted in the
battery connector.
Connect the battery charger cable connector to the battery connector again.
The plug on the battery charger's
power cable is not correctly inserted
into the electrical outlet.
Check that the battery charger power supply cable plug is connected to the
mains socket.
The characteristics of the mains
power supply do not correspond to
those required by the battery charger.
Check that the characteristics in the battery charger plate are the same as
those of the mains supply.
The LEDs of the battery charger blink
repeatedly.
Referring to the battery charger use and maintenance manual, check the
meaning of the flashing signals that the battery charger emits dung the
battery recharge stage.
THE MACHINE HAS
A VERY LOW WORK
AUTONOMY
Check the battery charge level, check
the symbol on the command display.
If the battery charge level is critical, perform a complete recharge cycle (see
paragraph CHARGING THE BATTERIES ”).
THE MACHINE
DOES NOT MOVE
The machine does not start. Read the section “THE MACHINE DOES NOT START”.
There is an issue on the drive pedal. Contact your nearest service centre.
INSUFFICIENT
DETERGENT
SOLUTION ON THE
BRUSHES
The quantity of detergent solution in
the water system is not sufficient for
the work to be carried out.
Check that the amount of detergent solution present in the machine's water
system is sufficient for the work to be carried out.
Detergent solution filter obstructed.
Check the detergent solution filter isn't obstructed. If it is, clean it (see
“ CLEANING THE WATER SYSTEM FILTER ”).
THE MACHINE
DOES NOT CLEAN
CORRECTLY
The machine does not start. Read the section “THE MACHINE DOES NOT START”.
Not enough detergent solution comes
out.
Read the section “INSUFFICIENT DETERGENT SOLUTION ON THE
BRUSHES”.
The brushes have not been inserted
correctly in the machine.
Check that the disc brushes are correctly inserted inside the machine.
The type of brush used is not suitable
for the dirt to be cleaned.
Check that the brushes on the machine are adequate for the work to be
carried out, contact the nearest technical assistance centre.
The brush bristles are excessively
worn.
Check the state of wear of the brush and, if necessary, replace it.
43