REVERSE FUNCTION
This machine is equipped with electronic traction control. To reverse, proceed as follows:
1. Engage the “REVERSE GEAR ACTIVATION/DEACTIVATION” lever (1) underneath the steering wheel (
Fig.1
).
2. Press the drive pedal (2) (
Fig.2
); in this manner the machine will begin to move in reverse.
CAUTION:
the reverse speed is lower than the forward speed to comply with current health and safety standards.
N.B.:
In order to disengage the reverse gear, disengage the lever (1) underneath the steering wheel (
Fig.1
).
N.B.:
Once the lever has been engaged (1), the acoustic signalling device will be activated in order to signal that
the machine's reverse gear has been engaged.
N.B.:
If the reverse gear is engaged with the squeegee in its working position, once the drive pedal is pressed, the machine will begin to
move in reverse and the squeegee body will be raised into its resting position.
N.B.:
If the reverse gear is engaged with the brush head in its working position, once the drive pedal is pressed, the machine will begin to
move in reverse and the brush head will remain in its working position, but the solenoid valve will stop dispensing detergent solution to the
brushes.
N.B.:
if you reverse with the video camera accessory (optional), the image is shown full screen.
N.B.:
if you reverse using the anti-collision system (optional) a special function activates that manages the ON/OFF frequency of the
buzzer. Every 50ms a trigger signal is sent to the ultrasound sensor, the sensor returns a signal that remains active for a period that is
inversely proportional to the distance of the reflecting object.
2
1
1
2
BUZZER
The machine is equipped with a buzzer. if you need to sound a warning, just press the button (1) on the steering column
(
Fig.1
).
1
1
EXTRA BRUSH HEAD PRESSURE
This machine is capable of increasing the pressure exerted upon the brushes during the work cycle. This can be done in the following manner:
1.
Check that the brush head body is in contact with the floor, if not select in the DS selector the programs “SCRUBBING WITH DRYING” OR
“SCRUBBING WITHOUT DRYING” (
Fig.1
).
2. Engage the “EXTRA-PRESSURE ACTIVATION/DEACTIVATION” lever (1) underneath the steering wheel (
Fig.2
).
3. Press the drive pedal (2) (
Fig.3
) to initiate the machine's working cycle.
N.B.:
as soon as the lever (1) is shifted the control display will show the “POWER” screen (
Fig.4
), in the middle of the screen there is a
graphic symbol (3) and a numeric symbol (4), these represent a countdown.
N.B.:
when the extra-pressure function is activated, the countdown starts. During this time, a pressure stronger than the standard
pressure is exerted on the brush head body.
SMART DRYING MODE
When moving from the scrubbing with drying program to the transfer program (see “
”), the drying function is delayed by a “Reset Delay” time.
N.B.:
While the function is active, the image in
Fig.1
will be displayed on the control panel.
At the end of the "Reset Delay" time, the squeegee body is moved into the rest position (raised off the floor) and
the suction motor is switched off with its "Reset Delay" time.
N.B.:
it is possible to cancel this function in advance by pressing the “X” symbol as seen in
Fig.1
.
N.B.:
at the end of the smart drying function, the image in
Fig.2
will be displayed on the control panel.
1
2
27
