ADJUSTMENT
AND
INSPECTION
MAGNA 85 – 100 BS
Doc.
Issued 12/2006
Rev. 00
Pag.
14 di 18
6.
Repeat the process on the
back motor cable
(cable N° 20A):
Trimmer Idx
and
Trimmer Tdx
(after the intervention of the
card, the right lamp remains switched on).
7.
Block the trimmers with anti loosening seal.
8.
Check under working conditions if both motors have a similar
current consumption with a max. tolerance difference of 2-4
ampere. If you get substantial differences change the
inclination of the brush base (see point 3 of the adjustments
and checks of the brush base unit).
Adjustment of the card for the delay (floating switch)
3.
Switch on the vac motor and lift manually the floating
switch and check to have a delay of about 4 sec for the
stop of the motor. In case adjust the
trimmer
on the card.
4.
Block the trimmer
.
Adjustment of the lateral bars
1.
Adjust the front part of the lateral bars: Adjustment of the
knobs
until the rubber touches slightly the floor.
2.
Adjustment of the back part of the lateral bars: Adjust the
lock nut
, so that the rubber is slightly bended; block it with
the clip.
