ADJUSTMENT
AND
INSPECTION
MAGNA 85 – 100 BS
Doc.
Issued 12/2006
Rev. 00
Pag.
9 di 18
Adjustment using the console
Inserting the console
1.
Check that all switches are off.
2.
Lift the front wheel on the safety stand.
3.
Insert the console into its connector with the key off.
4.
Turn on using the key.
5.
Either “HO AUTOSTOP V1.0 36V 200A 00000” or “*Alarm* abcdef …” will appear when it
starts up
6.
Press seat.
7.
Press ENTER to access the main menu.
Programming the chopper
Console Display
1.
Press ENTER to access the main menu.
2.
The first item appears: “PROGRAM” = CHANGE PARAMETERS.
3.
Press ENTER and check, scrolling with ROLL, if programming values
comply with the previous table.
* SELECT MENU *
1- PROGRAM
4.
At the end press OUT and confirm with ENTER (in reply to “DO YOU
WANT TO SAVE DATA?”) if a parameter has been changed (using the
PARAM SET push-buttons on the console).
WARNING: SAFETY PARAMETERS CANNOT BE VARIED, SUCH AS
ACCELERATION, BRAKING, ETC.
ONLY SPEED CUTBACKS CAN BE VARIED (CUTBACK SPEEDS 1 AND
2).
5.
If the chopper memory is lost use ROLL to select “RESTORE” =
REPROGRAM CHOPPER PARAMETERS:
* SELECT MENU *
4- RESTORE
6.
Press ENTER.
7.
The PROGRAM 01 code appears (use ROLL to select the desired
PROGRAM):
* SELECT PROGRAM *
PROGRAM 01
8.
Press ENTER to confirm loading the program.
9.
A request for confirmation appears, press ENTER = YES, OUT= NO :
ARE YOU
SURE?
10.
Press ENTER to confirm the loading procedure.
11.
The stand-by message appears while loading the parameters:
WAIT!
12.
At the end the following message returns:
* SELECT MENU *
4- RESTORE
