Fiery E-41, Инструкция по установке и обслуживанию

Страница: 69 / 161

S
ERVICE
P
ROCEDURES
69
3. Secure cables as necessary with any plastic cable clamp that you may have removed earlier.
4. Replace the video board in motherboard connector J12 (see Figure 20 on page 62 ).
Make sure to install the board mounting bracket screw to secure the board to the chassis. Press
down firmly on the top of the board as you insert the screw.
N
OTE
:
Make sure that unused back panel slots are covered with slot covers. Uncovered slots
reduce air flow and may cause the E-41 to overheat.
5. If you reinstalled the old motherboard, reassemble the E-41 and verify its functionality (see
page 104 ).
6. If you replaced the motherboard with a new motherboard, clear the CMOS as follows:
N
OTE
:
You must clear the CMOS after installing a new motherboard to ensure compatibility
between the new component and the previous settings stored in the BIOS. Make sure that the
power cable is removed from the power outlet before clearing the CMOS.
• Remove the battery (see page 84 ).
• Wait 2 minutes to allow the motherboard electrical components to fully discharge.
• Reinstall the battery.
7. If you replaced the motherboard with a new motherboard and cleared the CMOS, do the
following:
• Reassemble the E-41 (see page 104 ).
• Reset the time and date in Setup (see the Configuration and Setup ).
• Proceed to “Verifying new motherboard installation and transferring options” on page 70 .