Fiery E-41, Инструкция по установке и обслуживанию

Страница: 15 / 161

P
REFACE
15
• Handle the E-41 LCD window with care.
If the E-41 LCD window breaks and the liquid crystal inside leaks out, avoid contact with it.
If you come in contact with the liquid crystal, wash it off your skin immediately with soap
and water.
• Use care when handling parts of the E-41, as some edges on the unit may be sharp.
• Do not install third-party applications onto the E-41. Third-party applications are not
supported and can cause system problems. Although virus scans are permitted on the E-41,
virus-protection software should not be loaded in memory-resident mode.
• Do not change the Windows operating system software preference settings.
Depending on the changes made, the E-41 may become unstable or even unusable. If this
occurs, we recommend that you reinstall the E-41 System Software, which reliably restores the
Windows operating system software to its factory defaults.
• Never alter an existing network without permission.
The E-41 will probably be connected to an existing Local Area Network (LAN) based on
Ethernet hardware. The network is the link between the customer’s computer, existing laser
printers, and other prepress equipment. Never disturb the LAN by breaking or making a
network connection, altering termination, installing or removing networking hardware or
software, or shutting down networked devices without the knowledge and explicit permission
of the system or network administrator or shop supervisor.
• Unless you are the network administrator, never assign an IP address in E-41 Network Setup.
In a DHCP environment, the system assigns the IP address automatically. In a non-DHCP
environment, you should enter only the IP address that has been assigned by the network
administrator. Only the network administrator should assign an IP address to a network
device. Assigning the E-41 an incorrect IP address may cause unpredictable errors on any or
all devices connected to the network.