THE FOLLOWING HARMONIZED RULES HAVE BEEN UTILIZED FOR THE CORRECT IMPLEMENTATION OF
THE ESSENTIAL REQUIREMENTS OF HEALTH AND SAFETY OFTHE ATTACHED I.
• EN 55014-1: 2006
• EN 55014-2: 1997+A1:2001
• EN 61000-3-2: 2006
• EN 61000-3-3: 1995+A1:2001+A2: 2005
• EN 60335-2-71:2003+A1:2007
Guanzate The Declarer
The metallic
plate fixed on the machine is an integral part of the same; all serial numbers, and product
specifications are detailed on the plate.
TROUBLE SHOOTING CHECK LIST
Before asking for a technical assistance service, please follow this list to try to solve most common problems:
PROBLEM
CAUSE
SOLUTION
The machine does not work
Lack of power
Check the plug
Plug disconnected
Put the plug into the socket
Safety fuse burnt
Replace the fuse
Working temperature
Heating element not correctly
Contact the manufacturer
not sufficient
working
Thermostat not calibrated
See instruction for calibration
Thermostat faulty or not working
Contact the manufacturer
Door open
Close the door
Cold room under 17/18°C
Place the incubator in a warmer room
Egg-turner device not
Egg-turner motor broken
Contact the manufacturer
working properly
Egg-turner motor disconnected
See egg-turner motor
connecting paragraph
Forced ventilation
Fan not working
2
Contact the manufacturer
not sufficient
Thermometer alcohol
Accidental drops or jarring
Try to put the thermometer
column interrupted
of the thermometer
at low temperature (in a freezer)
for few minutes, and then allow
to return to room temperature.
Otherwise replace the
thermometer
Whichever reparation attempt not included on above mentioned form is severably forbidden.
Contact always the manufacturer or the authorized technical assistance in your country.
tel. 0039 031 / 97 66 72, fax.0039 031 / 899163 oppure il punto vendita autorizzato.
www.fiem.it - www.fiem.eu – emails: [email protected] – [email protected] – [email protected]
2
The working of the fan will be checked by sight, its bad working could compromise incubation results
17
Содержание CIP CIP 28
Страница 2: ...2 ...
