FIC PA-2010+, Руководство пользователя, Страница: 57 / 76

PA-2010+ Mainboard Manual
The options are: Enabled (Default), Disabled.
Boot Sequence (LS120)
Allows the system BIOS to first try to boot the operating system from the
selected disk drive. The options are: A, C, SCSI (Default); C, A, SCSI; C,
CDROM, A; CDROM, C, A; D, A, SCSI; E, A, SCSI; F, A, SCSI; SCSI, A,
C; SCSI, C, A; C only; LS120, C.
Swap Floppy Drive
Allows you to switch the order in which the operating system accesses the
floppy drives during boot up. The options are: Enabled, Disabled (Default).
Boot Up Floppy Seek
When enabled, assigns the BIOS to perform floppy diskette drive tests by
issuing the time-consuming seek commands. The options are: Enabled
(Default), Disabled.
Boot Up Numlock Status
When set to On, allows the BIOS to automatically enable the Num Lock
Function when the system boots up. The options are: On (Default), Off.
Gate A20 Option
When set at Fast, allows a faster access response under Protected mode.
The options are: Fast (Default), Normal.
Typematic Rate Setting
The term typematic means that when a keyboard key is held down, the
character is repeatedly entered until the key is released. When this item is
enabled, you may change the typematic repeat rate. The options are:
Disabled (Default), Enabled.
Typematic Rate (Chars/Sec)
Sets the rate of a character repeat when the key is held down.
The options are: 6 (Default), 8, 10, 12, 15, 20, 24, 30.
Typematic Delay (Msec)
Sets the delay time before a character is repeated.
The options are: 250 (Default), 500, 750, 1000 millisecond.
42