52/76
Operating instructions WPM Gateway IoT
Set up WPM Gateway
8.5
Sensors – Changing parameters
In the
Configuration
view of a sensor, the individual parameters of a sensor can be changed.
Open view:
Main menu => Data holder =>
=> Sensors
=>
=> Configuration
Fig. 8-7 Sensors – Changing parameters
Change sensor name
1) Enter a new sensor name in the
Sensor
name input field (maximum 15 characters).
2) Click the
Save
button to apply the new sensor name.
Sensor – Lock changes
1) In the
Lock
selection box, activate the lock parameter by checking the check box.
–
If Lock parameter is enabled, sensor parameters can only be changed after confirmation
via a confirmation prompt.
2) Clicking the
Save
button applies the new status to the lock parameter.
The other parameters of a sensor can be changed in the same way.
Descriptions of the parameters can be found in Chapter 7.4.3.2 "Current parameters of a sen-
sor" on page 43.
Sensor – Delete measurement data
In certain cases, it is useful to delete the collected measurement data of a sensor for the cur-
rently assigned data holder.
Example: This is necessary, for example, when a sensor in the WPM Gateway is assigned to
another data holder for another press tool, but the sensor is not installed until later. In this case,
the data collected from the sensor up until the installation does not match the data holder and
should be deleted.