9
7.1
7.2
7.3
7.4
In case the pad should seize:
– Remove the brush insert.
– Insert the special spanner (7.4) through the slot
(7.2) and place on spanner fl ats of tool.
– Release the tool with the spindle stop pressed by
turning the special spanner.
Please note:
Always screw the sanding pad onto the
drive spindle by hand. This will make it considerably
easier to remove it subsequently.
Attaching the abrasive
Stickfi x is a hook-and-loop fastening sys-
tem. Stickfi x sanding pads allow the use
of self-adhesive hook-and-loop abrasives
such as Stickfi x sandpapers and sanding
cloths.
Simply press the abrasive onto the sanding pad and
pull it off again after use.
Use only abrasives with an undamaged
Stickfi x hook-and-loop coating. Before use, check
that the coating has not been damaged by improper
use (such as over heating).
In the case of a weakening adhesive
effect of the StickFix surface, the sanding pad ac-
cessories, in particular those which are not yet
touching the workpiece,
may come loose from
the sanding pad and cause injuries
. Replace the
sanding pad!
The Mini-Stickfi x D 52 sanding pad was
developed for use in confi ned spaces and with small
areas. This small-diameter pad and the affi xed
abrasive will inevitably heat up in use more than
larger pads, since the same pressure is distributed
over a smaller area. Sand only with moderate pres-
sure and do not sand continuously for too long. Lift
the sander off the workpiece at intervals to allow
friction heat to dissipate.
Working with the tool
Always secure the workpiece in such
a manner that it cannot move while being sanded.
Never overload the tool by using too
much pressure! The best sanding results are
achieved when applying moderate pressure. Sand-
ing performance and quality depend primarily on
the choice of the right abrasive.
For safe guidance, always hold the tool
with both hands.
We recommend the following settings on the rotary
control (2.1) for electronic machines:
6
• Sanding hard GRP components (limited suit-
ability).
3 - 6
• Sanding off dry, cracked paint.
• Stripping anti-fouling paints.
• Sanding wood.
2 - 4
• Sanding paint/varnish with tendency to smear
• Light sanding of thin top coats of paint.
• Cleaning sandstone, concrete, formwork materi-
als.
1 - 2
• Sanding thermoplastic materials.
Maintenance and care
All maintenance or repair work requir-
ing the motor housing to be opened must be carried
out only by an authorized service workshop. Mainte-
nance or repair work carried out by an unauthorized
person can lead to the incorrect connection of the
wiring or other components, which in turn can lead
to accidents with serious consequences.
Always remove the plug from the
mains supply socket before carrying out any work
on the machine!
Always keep the tool and in particular the ventila-
tion slots clean.
The tool is fi tted with special motor brushes with
an automatic cut-out. When the brushes become
worn the power supply is shut off automatically and
the tool comes to a standstill.
Содержание RAS 115 E
Страница 2: ......
