Festo MS6-SV Series, Инструкция по эксплуатации

Страница: 25 / 38

Fig. 18 Example of error code
After 4 short flash pulses of the Power LED 1 , there are 6 long flash pulses of the Error LED 2 . This
indicates error code 6 (pneumatic fault). A pneumatic fault occurs, for example, if the operating pres-
sure is below the required minimum pressure or there is no pressure at all.
11.2 Fault clearance
– Check compressed air supply
– Check power supply
– Check installation of the signal lines
– Start device .
– If the fault occurs again: contact Festo service
è
www.festo.com.
Malfunc-
tion/
error code Possible cause Remedy
2 Bouncing on the enable signals – Make sure that only debounced con-
tacts are used (e.g. for protective
guards or doors).
Power supply is insufficient – provide sufficient power supply. 5
Power unit is not correctly dimensioned;
voltage collapses – use a sufficiently dimensioned power
unit.
6 Pressure supply was interrupted – Restore compressed air supply.
Enable signals outside the specification – Comply with specification . 8
Multi-pin plug socket NECA or cable is
defective – NECACheck multi-pin plug socket or
wiring and replace if defective.
PLC emits test pulses that are offset to the
enable signals – Switch off test pulses.
– Use MP5 plug connector.
Additional
Error codes
Malfunction due to electrical or electro-
magnetic effects (EMC information not in
compliance) – note maximum length of the signal
lines.
– Connect earthing correctly.
– maintain minimum wall distance.
– Do not install cables behind the
product.
Malfunctions
25 Festo — MS6-SV-...-E-10V24 — 2019-10d