Festo MPA-ASI Series, Руководство пользователя

Страница: 165 / 208

5. Maintenance and conversion
5−37
Festo P.BE−MPA−EN en 0802c
Components MPA−S valve terminal with ...
CPX terminal multipin connection
For each sub−base or pneumatic supply plate
added the appropriate seal or isolating seal:
Seal
Isolating seal
MPA−DPU or MPA−DP
Channel 1 separate: MPA−DPU−P or MPA−DP−P
Channels 3 and 5 separate:
MPA−DPU−RS or
MPA−DP−RS
Channels 1, 3 and 5 separate: MPA−DPU−PRS or
MPA−DP−PRS
Tab.5/10: Valve location extension
Dismantling Proceed as follows:
1. Loosen the MPA−S valve terminal from the fastening
surface (see section Dismantling the MPA−S valve
terminal").
2. Remove the sub−base or supply plate at the point where
you wish to extend the valve terminal (see section 5.3.6).
3. Only MPA−S valve terminal with multipin connection:
If you wish to fit a further sub−base on the last sub−base
before the right−hand MPA end plate, you must remove
the end piece type MPA from the last manifold board.
1
End piece
typeMPA
1
Fig.5/17: Removing/fitting the end piece of the last manifold board