Festo CPX-AP-I-EC-M12, Инструкция по эксплуатации

Страница: 12 / 38

ID Parameter Instance-
s Data
type Access
1)
Arraysize
20022 Configuration of voltage monitoring load
supply PL
–
0: load voltage monitoring inactive
– 1: load voltage monitoring active, with
suppression of diagnostics at switch-
off (factory setting)
– 2: load voltage monitoring active
1 UINT8 rw
–
20059 AP Sync operating mode 1 ENUM_ID ro
–
20085 Measured value temperature AP-ASIC [°C] 1 INT16 ro
–
20087 Current measured value of logic supply PS
[mV] 1 UINT16 ro
–
20088 Current measured value of load supply PL
[mV] 1 UINT16 ro
–
20092 Operating time [s] 1 UINT32 ro
–
20093 Hardware version 1 UINT8 ro
–
20196 Diagnostic status
–
Index 0: diagnostic status of the entire
automation system CPX-AP
– Index 1: diagnostic status of module 1
(address 1)
– Index 2: diagnostic status of module 2
(address 2)
– ...
Each entry is of the data type UINT8 with
the following meaning:
–
Bit 0: degree of severity information (1)
– Bit 1: degree of severity maintenance
(1)
– Bit 2: degree of severity warning (1)
– Bit 3: degree of severity error (1)
– Bit 4, 5: reserved
– Bit 6: module present (1), module lost
(0)
– Bit 7: reserved
Bit 6 is not valid for index 0.
1 UINT8 ro Number
of mod-
ules + 1
1130125 Bootloader version 1 CHAR ro 40
1) ro = read only; rw = read write
Tab. 12 Parameter
Parameterisation
12 Festo — CPX-AP-I-EC-M12 — 2019-11