Festo 1971599, Руководство пользователя

Страница: 102 / 150

3. Commissioning
3-12
Festo P.BE-CPX-FVDA-P2-EN en 1209NH English
Module parameter: Monitoring wire break Operator unit
Bit Monitor wire break
Bit 0:
output channel 0
Bit 1: output channel 1
Bit 2: output channel 2
Bit 3 ... 7: reserved
[Monitor wire break]
[Channel 0]
[Channel 1]
[Channel 2]
Values 0 = inactive
1 = active
Presettings:
– Output channel 0: inactive
– Output channel 1: inactive
– Output channel 2: inactive [Inactive]
[Active]
Note Wire break monitoring is possible only with a switched-on output channel. If
monitoring is active and a wire break occurs, the error LED of the corresponding
channel flashes. If monitoring is switched off, any diagnostic message present is
reset. A wire break diagnostic does not switch off the output channel.
Tab. 3/7: Monitoring of wire fracture (channel-specific)
Module parameter: DIL switch setting Operator unit
Function no. 4828 + m * 64 + 22 m = module number (0 ... 47)
4828 + m * 64 + 23
Description Specifies the switch setting of the PROFIsafe address selection switch on the
module.
In addition to the PROFISsafe parameter F_DEST_ADD (
section 3.4), the set-
ting of the address selection switch can be read out through CPX parameters for
diagnostic purposes – e.g. with the operator unit (read only).
Bit Low byte (4828 + m * 64 +
22)
Bit 0: SW 0
Bit 1: SW 1
...
Bit 7:
SW 7
High byte 4828 + m * 64 +
23)
Bit 0: SW 8
Bit 1: SW 9
Bit 2 ... 7: reserved or 0
[PROFIsafe Addr]