Ferroli RVL-I PLUS, Руководство по установке и обслуживанию

Страница: 54 / 92

54
Door 1
: Gives access to the compressor compartment
and electrical parts
Door 2
: Gives access to the hydraulic compartment
and electrical parts
Door 1
: Gives access to the compressor compartment,
to the hydraulic compartment and to the electrical parts
Opening the unit
1 2
1
1 2
1
Switch off all power — i .e . unit power supply and backup heater and domestic hot water tank power supply (if applicable) —
before removing doors 1 and 2 .
Push the grill to the left until it stops . then pull its right edge, the grill can now be removed . You can also reverse the procedure .
Exercise caution to avoid a possible hand injury.
Parts inside the unit may be hot .
WARNING
CAUTION
SAFETY AND MAINTENANCE
MOD . 10-14-14T
MOD . 5-7
The installer is obliged to verify correct operation of unit after installation .
If required, the installer can perform a manual test run operation at any time to check correct operation of air purge, heating,
cooling and domestic water heating, refer to section " SETUP OF THE SYSTEM" .
Test run operation (manual)
That during the first running period of the unit, required power input may be higher than stated on the nameplate of the unit. This
phenomenon originates from the compressor that needs elapse of a 50 hours run in period before reaching smooth operation
and stable power consumption .
NOTE