Ferrari 2006 F430 Spider, Руководство пользователя

Страница: 89 / 154

3 - Driving your vehicle
89
When the vehicle is stationary, a
N
,
1st
gear
or
R
request will not result in a change from
“Automatic” to “Normal”.
The “Automatic gearshift” mode can only
be exited by operating the AUTO control
button.
Push start
In the event that the ignition system
malfunctions, you can “push start” the
vehicle as follows:
• Run the “Turning on the system”
procedure (see page 85 );
• As the vehicle picks up speed, request an
upshift with the gearshift in N .
This procedure should be avoided unless there
is an emergency situation!
Restarting the engine
In the event that the engine is turned off
accidentally, restart it using the relevant
button (see page 86 ) turning the key to
0
and then to
II
(On): the engine will start
immediately.
If the engine does not start, turn the key
back to position 0 before repeating the
procedure.
• After the engine has been started,
CHECK OK will appear. If CHECK OK
does not appear, turn the key back to
position
0
, wait a few seconds and retry.
If the engine fails to start after several
attempts, check for one of the following
causes:
• insuffi cient speed of the starting motor
(e.g., fl at battery);
• ignition device faulty;
• faulty electrical contacts;
• fuel pump fuses blown.
Starting and driving
the vehicle (Mechanical
gearbox)
Starting the engine
Before starting the engine, make sure that
the alarm system and all electrical devices
are turned off.
• Check that the handbrake is engaged.
• Put the gearshift lever into neutral.
R
2
4
6
1
3
5
• Fully depress the clutch pedal without
pushing the accelerator.
• Turn the key to position II : and wait for
the wording CHECK OK to appear on
the multi-function display.
Press the ENGINE START button and
release it as soon as the engine starts. Do
not hold the ENGINE START button
pressed down for a long time.