Enable Virtual Servers
: Check to enable the Virtual Server function.
Servers
: You can set up a local server with specific port number that
stands for the service (e.g. web (80), FTP (21), Telnet (23)). When
this device receives an incoming access request for this specific port,
it will be forwarded to the corresponding internal server. You can
add virtual servers by either port numbers or by names.
Maximum 24 Server entries are allowed and each port number can only
be assigned to one IP address.
Local IP Address
: Enter the Local Server’s IP address.
Protocol
: Select the protocol (TCP, UDP or Both) used to the remote
system or service.
Port Range
: For TCP and UDP Services, enter the beginning of the range
of port numbers used by the service. If the service uses a single port
number, enter it in both the start and finish fields.
Description
: You may key in a description for the local IP address.
Save
: Click to save and apply the current settings.
Reset
: Click to clear and rest the current settings.
Current Virtual Servers table
: Shows the current virtual servers
information.
Special
Application
Click to enter the Special Application screen.
