FENIX IMVICO
TK-41 OPERATION MANUAL
61/88
ESC M n
[Name]
Select character font
[Format]
ASCII
ESC M
n
Hex
1B 4D
n
[Range]
n
= <00>H, <01>H
[Description] Selects the character font.
n
Function
<00>H
Character Font A (12 x 24) selected
<01>H
Character Font B (8 x 16) selected
[Notes]
•
ESC !
can also select character font types. However the setting of the last
received command is effective.
•
This command must be sent at the beginning of a line. If it is sent in the
middle of a line, all previous data in the print buffer is printed and the ticket is
placed at the beginning of the next line.
[Reference]
ESC !, APPENDIX A
ESC c 3 n
[Name]
Select paper sensor(s) to output paper-end signal in the parallel port.
[Format]
ASCII
ESC c 3
n
Hex
1B 63 33
n
[Range]
<00>H
≤
n
≤
<01>H
[Description] Selects the paper sensor(s) to output paper-end signal, using
n
as
follows:
Bit
OFF / ON
Hex
Function
0
OFF
00
Undefined.
OFF
00
Paper roll near-end sensor disabled.
1
ON
02
Paper roll near-end sensor enabled.
2
-
-
Undefined.
OFF
00
Paper roll end sensor disabled
3
ON
08
Paper roll end sensor enabled
4-7
-
-
Undefined.
[Notes]
•
It is possible to select both sensors to output the signal. Then, if any of the
sensors detects a paper-end, the paper-end signal at the parallel port is
output.
•
Normally, the paper-near-end error is detected by directly reading the
parallel port (see point 3.5.2- PAPER-NEAR-END ERROR). When setting
the paper-near-end sensor to activate the PE signal in the parallel port,
the distinction between “paper-near-end” and “no paper / head-up”
errors must be very accurate, for they are indicated in a very similar
way.
[Default]
n
= <08>H
