Fender Tone Master Super Reverb, Руководство пользователя

Страница: 3 / 12

2
EN
GL
ISH
REAR PANEL
P.
IEC INLET: Connect included power cord to a grounded
outlet in accordance with the input power voltage and
frequency beside inlet. Universal 100V-240V operation.
Q.
POWER: Turns amplifier on and off.
R.
MUTE: Mutes power amp. When in MUTE mode, XLR line
output remains active for studio or “quiet stage” use, and
POWER JEWEL (O) illumination changes from red to amber.
S.
OUTPUT POWER: Selector switch offers full power (45
watts) and five other attenuated wattage settings that tailor
room/venue overall loudness. Set amp front-panel channel
volume to personal preference for tube-emulated response,
then set OUTPUT POWER to preferred level.
T.
CABINET SIM: When using XLR BALANCED LINE OUTPUT
(W), this switch offers three different tonal options—a flat,
uncolored amp signal without speaker cabinet emulation
(OFF); and two impulse response (IR) profiles emulating
different speaker/ microphone-placement combinations:
IR PROFILE 1: Dynamic microphone close-mic’ed at edge
of speaker cone center cap for pronounced attack and
definition. IR created using a Shure® SM57 microphone.
IR PROFILE 2: Ribbon mic, close-mic’ed for increased
smoothness and bass response. IR created using a Royer
Labs® R-121 Studio Ribbon microphone.
U.
BALANCED LINE OUTPUT LEVEL: Adjusts output level of
XLR BALANCED LINE OUTPUT (W) for external devices and
systems (i.e., PA and recording gear), whether mic or line level.
V.
GROUND LIFT: When using the XLR BALANCED LINE
OUTPUT (W), engaging this button may eliminate hum or
buzz resulting from connection to improperly grounded
equipment.
W.
XLR BALANCED LINE OUTPUT: For balanced connection
to external devices and systems (i.e., PA and recording
gear). XLR line output remains active when amp is in
MUTE mode (R).
X.
FOOTSWITCH: Connect included two-button footswitch
for reverb and tremolo on/off here.
Y.
USB PORT (NOT SHOWN): For firmware updates, a USB
port is located on the underside of the chassis beneath
the OUTPUT POWER section. Visit
fender.com/firmware/
support
for periodic firmware updates that improve and
enhance the Tone Master experience .
All non-FMIC product names and trademarks appearing in this
manual are the property of their respective owners and are used
solely to identify the products whose sounds were studied during
IR development for this product. The use of these products and
trademarks does not imply any affiliation, connection, sponsor-
ship, or approval between FMIC and with or by any third party.
For questions and troubleshooting,
contact a Fender specialist at:
1-800-856-9801 (U.S. toll free)
1-480-596-7195 (International)
SPECIFICATIONS
TYPE
PR 5966
POWER REQUIREMENTS 450 watts (max)
POWER AMP OUTPUT
200 watts (simulates 45W tube amp performance)
INPUT IMPEDANCES Input 1 (both channels): 1MΩ Input 2 (both channels): 136kΩ
XLR LINE OUT IMPEDANCE
600Ω
SPEAKER Four 10” Jensen® P10R, 8Ω (PN 0055613000)
FOOTSWITCH
Two-button Tone Master (included, PN 7716005000)
COVER Included (PN 0041533000)
DIMENSIONS AND WEIGHT
Width: 25.12” (63.5 cm) Height: 24.75” (63 cm) Depth: 10.5” (26.5 cm) Weight: 36 lbs. (16.3 kg)
Product specifications subject to change without notice.