19
• energizer is completely switched off
and does not communicate.
This status is not indicated for the monitor.
Energizer state and its power
• power 50% -
the energizer is switched on and set to half power
see energizer G2
• power 100% -
the energizer is turned on and set to full power
see energizer G1
Last measured voltage at the fence [kV]
Signal level of the connected energizer
Displays the battery status when is connected to energizer or displays
status of monitor´s battery
Indication of activation of the audible alarm
- see page 21
Indication of last device response
Under each device is a bargraph, which signals the time since the last sent informati on
about the status of the remote device. The transmission interval between the energiter
and the gateway is each minute, between the monitor and the gateway every 15 minutes.
The bargraph is displayed from 2 minutes since the last transmission. If the entire device
is underlined, an alarm is set automatically. If at any time during the transmission with
information about the device, the bargraph is zeroed and starts to be timed again.
• power 0% -
energizer is off, the device communicates (in standby mode)
see energizer G3
20 minutes
60 minutes
2 minutes
5 minutes
