Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com
Page
37
of
51
12.2
GUIDE WIRES
Cut a piece of 20cm from the frame strips. Remove sharp edges, to
prevent damage to cables.
For your reference please put marks on the ends of
cables. During mounting it will become hard to
distinguish the cables when they reach the electronics
board.
Make a nice loop for the cables which come from the extruder. It must
be small/large enough that the cable doesn’t get stuck around the far
edge of the top beam, when the extruder is at its end position in x-
direction, but there should also not be too much tension.
Place the cables behind the just cut off strip.
Take the 3 wire cable and mount it onto the sensor as shown above.
Cut off 5cm and 12cm of strip and guide the cables as indicated above.
Mount the wires for the opto-sensors of the y and z-axis.
