19
en
Working instructions.
Before mounting or replacing application tools or accessories, pull the power
plug.
This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Do not use accessories which are not specifically designed and recommended by the power tool
manufacturer.
Safe operation is not ensured merely because an accessory fits your power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Connecting the dust extraction
(Figure 3-5).
When working materials that
produce dust, the power tool is
to be connected to an external dust extraction
via the extraction adapter.
The vacuum cleaner must be suitable for the
material being worked.
When vacuuming dry dusts that are particu-
larly hazardous to one’s health or carcino-
genic, a specialty vacuum cleaner is to be
used.
Switching ON and OFF (Figure 1).
First check that the power
cable and power plug are not
damaged.
Always hold the power tool
firmly.
Otherwise, you could
lose control over the power tool.
Switching ON:
➤
Push the switch towards the front (
I
).
Switching OFF:
➤
Push the switch towards the back (
0
).
Setting the oscillating frequency
(Figure 1).
The oscillating frequency can be set infinitely
variable with the dial control.
Increasing the oscillating frequency:
➤
Turn dial control in counterclockwise
direction.
Decreasing the oscillating frequency:
➤
Turn dial control in clockwise direc-
tion.
Securing the work piece.
Secure the workpiece firmly.
A
work piece that is gripped
tightly in a clamping device or vice, is more
secure than if held by hand.
Sanding
Typical application: Dry sanding of wood and
metal, especially of smaller surfaces, corners and
edges, as well as hard to reach locations.
Work with the complete surface of the sanding
plate, not only with the tip. Select a high oscillat-
ing frequency. Sand with continuous motion
and light pressure.
Applying excessive pressure
does not increase material removal; only the
sanding sheet wears more quickly.
Sawing
Typical application: Sawing of thin steel sheet,
wood and plastic components.
Select a high oscillating frequency.
Round saw blades can be clamped offset again
to provide uniform wear.
While sawing or plunge cutting, provide for
good chip removal by applying a light pendulum
motion.
Scraping
Typical application: Scraping off old coats of
varnish or adhesives, removing bonded car-
peting, e. g., on stairs/steps or other small/
medium-sized surfaces.
Select a medium to high oscillating frequency.
WARNING
CAUTION
WARNING
CAUTION
CAUTION
3 41 01 120 21 0.book Seite 19 Dienstag, 26. Mai 2009 2:21 14
