Fein Dustex 25L, Инструкция по эксплуатации

Страница: 28 / 286

28
en
Do not use accessories not specifi-
cally intended or recommended for
this vacuum cleaner.
Just because
the accessory can be attached to
your vacuum cleaner, it does not
assure safe operation.
Before starting operation (see page
6–9), check the power supply cord
and the mains plug for damage.
Use the vacuum
cleaner's socket
outlet only for connection of an
external power tool. The vacuum
cleaner is automatically switched on
and off via the connected power tool.
The connected load of the power tool
may not exceed the maximum con-
nected load P
A
of the vacuum
cleaner’s socket outlet.
Please also observe the operating
instructions and safety warnings of
the power tool being connected to
the socket outlet of the vacuum
cleaner.
Recommendation: Always operate
the vacuum cleaner via a residual
current device (RCD) with a rated
residual current of 30 mA or less.
The vacuum cleaner may only be
stored indoors.
Operating Instructions.
Operation, see page 10.
Filter replacement and filter cleaning,
see page 11–13/ 30 section “Fault
Finding.”
Never vacuum with-
out the flat-fold fil-
ter, as otherwise the motor will be
damaged and a health hazard will
occur through increased exposure of
fine dust. When vacuuming fine dust,
a fleece filter bag must be used addi-
tionally.
An adequate ventilation rate L must
be provided for when the outgoing
air is circulated. The circulated air-
flow must not exceed 50 % (max.)
of the fresh air volume (room vol-
ume x ventilation rate L
w
). The fol-
lowing applies without special
ventilation measures: L
w
= 1 h
-1
.
When inserting the fleece filter bag,
pay attention that the closing cover
and the fleece bag face completely
against the interior side of the con-
tainer.
After removing the fleece filter bag,
seal it with the closing cover in order
to avoid debris.
For vacuuming dusts of dust cat-
egory L, only dry flat-fold filters,
which have not been moist or wet,
are permitted to be used.
Before switching from wet to
dry vacuuming, allow the flat-
fold filter to dry or replace through a
dry one. Otherwise, the flat-fold fil-
ter will become unusable.
Keep the flat-fold filter dry and clean
it regularly.
Mount accessories applying only
slight pressure. For disassembling,
turn the parts somewhat against each
other and pull apart.
Switch the vacuum cleaner off before
connecting a power tool to the vac-
uum cleaner’s socket outlet. Make
sure that the power tool is switched
off when inserting its plug into the
vacuum cleaner’s socket outlet.
WARNING
CAUTION
OBJ_BUCH-0000000148-005.book Page 28 Monday, August 5, 2019 10:02 AM