![background image](http://html1.mh-extra.com/html/feig-electronic/id-isc-lru3000/id-isc-lru3000_installation-instructions-manual_3888020015.webp)
IDENTIFICATION
ID ISC.LRU3000 / LRU3500
4 Terminals
Page 15 of 30
4.3.5.1 Address assignment of RS485 for bus operation
For bus operation the Reader can be assigned the required bus address via software.
The address is assigned by the host computer.
The software is used to assign addresses “0” through “254” to
the Reader.
A potential termination of the interface bus can be configured by the software as well.
NOTE:
Since all Readers are factory set with address „0“, they must be connected and configured one after
the other.
4.3.6 Data-Clock Interface on connector X5 for Scan Mode only
The connection of the data-clock interface take place via the digital Outputs OUT1 and OUT2 at connector X5.
The wire for the clock needs to be connected to connector OUT1-C, the wire for the data needs to be connected
to connector OUT2-C.
Fig. 11: Data-Clock Interface on connector X5
NOTE:
For an easy installation with best signal quality we recommend the use of the ID ISC.LR.WS-A
Wiegand Switch (4955.000.00).
The data-clock interface is only available in Scan-Mode.
The data-clock interface cannot be used to configure the reader.
Clock / Data-0