OBID
i-scan
®
Application-Note
ID ISC.ANT800/600-DA
FEIG ELECTRONIC GmbH
Seite 18 von 26
N50101-0e-ID-B.doc
3.5. Tuning the Antennas
Before start tuning the antennas, the service software ISOStart has to be closed. After that the
antennas are tuned according to the following sequence:
Table 11: Tuning procedure
Step
Procedure
Note
1
Start the software
DATuningTool
2
Select
“Detect Reader...” and
then “Detect” on the
connected interface
(COM-Port 1)
3
Configure the Settings:
Dual Mode, Number of
Gates 3
with Multiplexer
Number of Tuning
Iterations 3
4
„Start Tuning“ and wait
until Tuning Procedure
has finished
...
...
5
After every Tuning
Iteration the actual
Tuning Status is
shown in the tree.
After a successful
tuning procedure both
antennas of gate1are
colored green in the
tree
After a successful tuning of the antennas the software DATuningTool has to be closed.
