THE CONTROL OF THE SAFETY VALVE
Check the condition of the safety valve before each use.
1.
Make sure that the tank doesn’t include the pressure. Manometer
(fig. 6E)
should indicate 0 bar.
2.
Pull the ring several times
(fig. 8).
The pin should be moved loosely.
3.
If is the pin blocked inside the safety valve, don't use the machine and contact authorized service.
Never adjust the safety valve by yourself.
AIR FILTER CLEANING
1.
Open the air filter cap
(fig. 4B).
2.
Remove the filter element.
3.
To loosen debris, gently tap the filter on a hard surface. Never try to brush the dirt off, brushing will
force dirt into the fibers. If the filter is excessively dirty, replace with a new filter.
MAINTENANCE TABLE
Perform maintenance more frequently if compressor is used near paint spraying operations or in dusty
environments.
All others maintenance and repairs shall be provided only by our service agent
CLEANING
CAUTION!
Never spray the product with water or expose it to water. Never use aggressive
detergents or solvents for cleaning.
Carefully clean the machine after each use.
Do not let the handles contaminate with oil or grease. Clean the handle clean with a damp cloth
washed in soapy water. Never use aggressive detergents or solvents for cleaning. This can cause
irreparable damage to the product. The plastic parts can be eaten away by chemicals.
Wipe down the product with a slightly damp cloth or with brush.
Clean the cover of the machine, especially the ventilation holes.
STORAGE
•
Store the machine out of reach of children.
Turn the motor off and disconnect the mains plug if the machine is not used.
Confirm that the outlet pressure is at zero (0) psi by fully turning the regulator knob to fully reduce air
pressure at the outlet.
• Remove the air tool or accessory.
• Let the machine to cool down. Drain water from air tank by opening drain valve on bottom of
tank. • Do not store the machine a long time in direct sunlight.
Before each use
Drain condensation from tank
Check for any unusual noise or vibration
Be sure all nuts and bolts are tight
Every 10 operating
hours
Clean air filter.
Every 40 operating
hours
Inspect air system for leaks by applying soapy water to all joints of
pressure circuit. Tighten those joints if leakage is observed (contact
the authorized service center).
Содержание FC6LS
Страница 5: ......
