find air leak, release the pressure from the air nozzle and before further use secure a control and
compressor repair at the authorized service center.
CAUTION!
Never use a compressor which has a compressed air leak!
Move the machine only by lifting the handle, never by pulling hoses and cables attached.
PREPARATION FOR OPERATION
WARING!
Compressor use, always store and transport in operating position (standing by supporting foot and
wheels on a level solid surface - tank down and compressor engine up. Compressor never tilt or upside
down!
CONNECTING AND DISCONNECTING OF THE AIR HOSE
The machine is equipped with quick-coupling to connect the air hose.
•
Use of the compressed air for the various purposes envisaged (inflation, air- powered tools, painting,
washing with water-based detergents only, etc.) requires knowledge of and compliance with the
rules established for each individual use.
•
Always bleed pressure from the tank before attempting maintenance, attaching tools or accessories.
When connecting an air-powered tool to a hose of compressed air supplied by the compressor,
interruption of the flow of air from the hose is compulsory.
Interruption of the flow of air from the hose is compulsory.
CONNECTING OF THE AIR HOSE
1.
Pull collar back in direction to manometer
(fig. 5A).
2.
Push the air hose connector into the socket
(fig. 5B)
and release the collar.
3.
Check if the air hose is connected properly.
DISCONNECTING OF THE AIR HOSE
1.
Push the air hose connector into the socket.
2.
Pull collar back in direction to manometer.
3.
Pull the air hose connector out and release the collar.
SETTING OF THE OPERATING PRESSURE
Adjusted operating pressure can be read on the manometer
(fig. 6C).
Rotate with the regulator
(fig. 6A)
according to the arrows for increasing or decreasing of operating
pressure (locking nut have to be loosened
(fig. 6B).
During pressure reducing is the change on the
manometer note only after the partial reduction of air.
The setting can be locked by red lock nut
(fig. 6B),
by adjust of needed pressure and the locking nut
unscrew to the knob. After the temporary reduction in pressure, it can be easily to set back the pressure in
the output needed by turning of the valve to the locking nut. For new pressure adjusting is necessary to
unscrew the lock nut to the bottom position. If you cannot turn the valve, it is probably too tight to the
lock nut.
CAUTION!
Never exceed the maximum operating pressure level of the connected device. Do not tighten the
lock nut by the excessive force.
OPERATION
Please, read carefully the following steps before using of machine:
Always bleed pressure from the tank before attempting maintenance, attaching tools or accessories.
•
Check if are the nuts and bolts tightened well
Содержание FC6LS
Страница 5: ......
