Operation Manual Universal Gluing Press “LEIMO”
12
Release 10/2017 – We reserve the right to make technical changes in the interests of further development
Gramsham 2 · D-84550 Feichten/Alz
Phone +49- 86 23 - 70 35 · Fax +49-86 23 - 70 36
[email protected]
www.feichtner-maschinenbau.de
Assembling
Height adjustment by means of grub screw
(headless screw)
8) Finally, tighten all bolts and nuts under constant
control of the parallelism of the framework firmly.
Check the parallelism from the upper to the lower
longitudinal strut.
9) Now place the mounted press arms into the frame
from above.
10) Thread (mount) the pad shoes from below and allow
them to engage at the same height.
11) Place a straight crossbar across the three pad shoes and check that the crossbar
is parallel to the upper longitudinal tube. It is necessary to check, if the crossbar rests even on all
three pad shoes. If it is required, adjust one or the other pressing arms in height using the grub
screws (headless screws). Check by means of a 90° angle whether the straight crossbar on the
pad shoes to the frame is at right angles and adjust the frame if necessary by adjustment.
