Fei Bao F18-f, Инструкция по сборке

Страница: 21 / 31

20
F E I B A O F 1 8 - f
This may not be necessary because of the epoxy glue used but just for security you can use
masking tape to hold the horn and linkage at 90' to the surface while drying.
Install the rudders with the supplied flat washers and hex 3mm bolts
For the flap and aileron servos you will need 12" extensions on the aileron servos. The flap
servos, of course, only travel down, so adjust your linkages and servos accordingly, so that they
are all the way at one end when the flaps are up(neutral, level with the wing), and all the way at
the other end when flaps are down. Note that you will need a servo reverse, a JR Matchbox, a
reversed servo, or two separate channels for normal setup of the flaps, or one will work
backwards. If you are using the popular Spektrum DX7 radio, you will not have a spare channel
to program the second flap to move correctly. Here is a trick to allow you to run both flap servos
off one channel with just a regular servo y-harness.
7: INSTALLING ORDNANCE ON WINGS
Using the supplied hardware, screw the wing tip missile holders in place then screw the
missiles in place, repeat this for the other wing.
Using the supplies hardware again screw on the drop tank / missile holders, they may be either
3mm thread or 4-40 threads depending on what the factory has in stock for blind nuts at the time
of making the wings. Take you time to check the threads before you mount the holders by gently
screwing in a 4-40 hex bolt first and if it is to loose then try a 3mm hex bolt.
Install them as the pictures shows. The missiles use self taping wood screws.