Fei Bao F18-f, Инструкция по сборке

Страница: 11 / 31

10
F E I B A O F 1 8 - f
Coat the center portion of each hinge with petroleum jelly. Use enough to keep any glue from
sticking, but make sure you do not get any petroleum jelly on the ribbed portion of the hinge that
needs to be glued. If you get any on this portion you must clean it off with Acetone or some
other kind of strong cleaner, then sand / scuff to allow adhesion. If you do not get proper
adhesion, the control surface could come out in flight, which in turn would most likely cause a
crash, depending on your flying skills.
. Coat the leading edge of each control surface with a thin layer of petroleum jelly to keep any
glue from sticking.
Note the flap hinges closest to the fuselage has been shortened at the factory to prevent them
from protruding into the carbon fiber spar.
Use a piece of 40 grid sand paper to scuff up the short ends by sanding them in a round
motion to roughen in a grove that gives a ribbed affect, like the larger ones have. Giving some
extra attention on these should give you proper adhesion.