Fei Bao F18-f, Инструкция по сборке

Страница: 14 / 31

13
F E I B A O F 1 8 - f
Repeat previous step for the other elevator.
Install the elevator servos as show in the pictures below and do not use the rubber grommets as
they may cause flutter if there is to much play.
Attach a 36" heavy-duty 22-gauge extension to each servo. Tape the connections for safety.
You can also drill a hole through the bottom on each side of the rear fuselage to allow easy
access to the hex bolts that secure the elevators which allows easy removal to transport your
model..
6: WING & RUDDER SERVO COVERS, SERVOS, EXTENTIONS
Remove the servo cover from the rudder servo bay. Keep the orientation of the servo cover
correct, do not flip or rotate the servo covers, as there may be slight variations in the screw holes
and they may not fit perfectly if you rotate the covers. You can do both rudder servo assemblies
at the same time, if you like.
Test fit your rudder servos. You want a metal-geared, high-powered mini servo. A standard
servo will not fit, and full micro servos generally lack enough mounting area on their ears to
make them really safe, even though many of them have plenty of power for your rudders. You
could also fit a surface-mounted flat servo. In this case, the Hitec 5125MG is excellent for this
application. Beware of just gluing the servos into place...if you break a servo gear and have to
remove the servo for maintenance, you are in big trouble.
Attach a 36" heavy-duty 22 gauge extension to the servo. Tape the connection for safety.
Feed the extension through the rudder