mr
.
steam
®
Electric Towel Warmers
Installation and Operating Instructions
________________________________________________________________
Sliding Escutcheon
Set Screw
Towel Warmer
Header
Finished surface of wall
Brass Insert
Screw
MODELS W542 & W634
Box Contents
• Towel Warmer
• (3) Small Screws
• (4) Bracket Escutcheons • (1) Wire Box Escutcheon
• (4) Large Screw
• (4) Bracket Set Screws
• (1) Wiring Box Set Screw • (4) Brass Inserts
• (1) Wire Box Flange
• (1) Allen Key
• Warranty
• Instruction & Operation
Manual
1. Remove Towel Warmer and parts from the packing materials.
2. Rotate the two upper and two lower brackets into position as
shown.
IMPORTANT:
DO NOT LOOSEN SCREWS TO SWIVEL
BRACKETS. LOOSENING SCREWS WILL CAUSE INTERNAL
LIQUID TO ESCAPE AND CAUSE PRODUCT DAMAGE.
3. Using the allen key provided, loosen the wiring
box set screw. DO NOT remove the wiring box.
4. Rotate the wiring box as shown. Tighten the set screw
firmly to prevent the wiring box from rotating.
NOTE:
The wiring box and brackets on model W542 can be
rotated in either direction to result in a right or left handed
wiring box.
5. Measure the towel warmer and mark the location where
the brass inserts will be mounted to hang the towel warmer.
Before securing the towel warmer to the wall check to
ensure the mounting points are level.
6. Using the screws provided secure the brass inserts to the
wall.
7. Gently slide the towel warmer onto the brass inserts as
shown and mark the location for the wiring flange.
8. Remove the towel warmer and secure the flange to the wall
per the instructions on page 7.
9. Before securing the towel warmer to the wall put an
escutcheon on each of the 4 brackets. The open end of
the escutcheon should face the wall as shown.
10. Secure the towel warmer to the brass inserts using the set
screws provided. When the towel warmer is secured to the
wall slide the escutcheons against the wall to hide the
mounting point.
If a single gang electric box has been
roughed in See page 3 for instructions.
Install Towel Warmers in upright position
only. Locate with indicator light on bottom as shown. Failure to
install properly may result in a hazardous condition.
Brass Insert
Upper
Brackets
Bracket
Escutcheons
Wiring Box
Flange
Wiring Box
Escutcheon
Lower
Brackets
Level
Wiring
Box
IMPORTANT:
DO NOT LOOSEN SCREWS
ON TOP OR BOTTOM BRACKETS. LOOSENING
SCREWS WILL CAUSE INTERNAL LIQUID TO
ESCAPE AND CAUSE PRODUCT DAMAGE.
5
!
WARNING
!
WARNING
