mr
.
steam
®
Hydronic Towel Warmers
Installation and Operating Instructions
________________________________________________________________
9
HYDRONIC MODEL H542
Escutcheons
Brass Inserts
Valves
Screws
Washers Set Screws Mounting Backet Escutcheons Eccentric Coupling
Suitable only for closed loop non-potable hot water systems.
Tighten Towel Warmer unions only. Do not turn valves as leaking may result
Do not use with water over 158 degrees F.
(7o˚ C) Do not use with steam. Using with steam or water over 158 degrees F or
20 psig, may result in scalding or hazardous conditions.
1. Read this entire instruction manual thoroughly before beginning
installation and save these instructions.
2. Follow instructions accurately to make certain the Towel Warmer is
properly attached to the wall. FAILURE TO FOLLOW THESE STEPS COULD
RESULT IN PROBLEMS.
3. Do not use an abrasive cleaner on the Towel Warmer. A mild
detergent will clean and restore most units to their original beauty.
4. TO ENSURE FULL EFFICIENCY OF YOUR TOWEL WARMER, PLEASE
FOLLOW ALL THE INSTRUCTIONS CAREFULLY, OBSERVING THE
“CAUTION” NOTATIONS FOR EACH STEP.
5. Inlet water temperature should be between 120°F and 158°F.
DO NOT exceed this limit. A burn hazard may result.
DO NOT alter or modify any Mr. Steam products. Doing so may result in an
inoperable or hazardous installation and will void the warranty.
.
Optional
Brackets
Additional towel warmer support brackets are available for installations
where plumbing does not provide a rigid support to secure the towel
warmer to the wall.
Bracket Part Numbers and Optional Finishes
Polished Chrome 103959PC
Polished Nickel 103959BN
Towel Warmer Installation Parts
-
Figure 1
Screws
!
WARNING
!
WARNING
!
CAUTION
