mr
.
steam
®
Hydronic Towel Warmers
Installation and Operating Instructions
________________________________________________________________
______________________________________
H O T W A T E R T O W E L W A R M E R S
______________________________________
Dimensions
(inches)
__________________
Model H
W D BTU/hr
†
Weight
(lbs.)*
______________________________________
H542
29
7
⁄
16
21
5
500
20
______________________________________
†
At 158˚ F *
without water
H
W
D
10
WALL PREPARATION
• DO NOT mount the Towel Warmer without providing
structurally secure headers as shown.
• DO NOT mount the Towel Warmer directly to sheet rock
or any other non-structural surface.
• Use longer fasteners as required if the finished wall surface
prevents adequate mounting with the screws provided.
• The recommended location for the optional lower brackets is
on the bottom most rung of the Towel Warmer as shown.
*Inlet/outlet pipe to be 18
1
⁄2” apart for all models
IMPORTANT NOTE:
Towel Warmers may have small dimen-
sional variations and must be measured prior to installation.
For Technical Service Assistance: East Coast Tel: 1-800-767-8326
West Coast Tel: 1-800-727-8326
Y1
Y2
(optional)
Minimum
Header
Size
2"x 6"
18.5"
Inlet/Outlet Pipe
Center to Center
22" Min Header Length
Sliding Escutcheon
Set Screw
Towel Warmer
Header
Finished surface of wall
Brass Insert
Screw
STEP 1: PRE-INSTALLATION
A. Select Installation Site: Make certain there is ample clear-
ance on both sides and back of the Towel Warmer.
NOTE:
This unit is supplied with the proper hardware for
installation. Be sure wall construction is appropriate for hang-
ing (see Step 3A, pg.11).
B. Before beginning the installation of any Mr.Steam Hydronic
Towel Warmer, please note the following:
Maximum operating temperature should not exceed 158°F.
Any working water temperature higher than 158°F could
create a potential burn hazard.
NOTE:
A closed loop non-potable hot water system is rec-
ommended. Consult an authorized hot water system installer
for hot water system types.
STEP 2: INSPECT THE TOWEL WARMER
A. Unpack the Mr.Steam Towel Warmer carefully to avoid any
damage or loss of any part. When opening the box and
unwrapping the Towel Warmer, be sure that parts are not
accidentally discarded (see illustration, Fig 1, pg.9).
B. Mr.Steam Hydronic Towel Warmers are shipped in spe-
cially designed shipping cartons. The entire surface of the
Towel Warmer is hand-wrapped to protect the finish. Check
the for any sign of damage.
!
CAUTION
MODEL
Y1
Y2
H 542
26
7
⁄
16
22
7
⁄
16
MOUNTING DIMENSIONS
(inches)
