Quick Reference Guide
E3980-10 VRSS Quick Reference Guide
Fo
r s
er
v
ic
e
pl
ea
s
e
c
al
l
(8
33
) 2
38
-81
6
8
or
em
a
il
tec
hs
ervic
e
@
pa
rtstow
n
.c
om
Fo
r s
e
rv
ic
e
p
le
a
s
e
c
a
ll
(8
3
3
) 2
3
8
-8
1
6
8
o
r
e
m
a
il
te
c
hs
e
rvi
c
e
@pa
rtsto
w
n
.c
om
17.1.3
Lifting and Moving the Case
CAUTION
Removing the case requires a minimum of two people. Do not attempt to remove this unit from the shipping
pallet by yourself.
CAUTION
Do not push or pull against the glass air deflector on front of case. Doing so can cause the glass to break. Do
not push or pull on side glass or pull on base panel. Doing so will break glass or pull out panel mounting screws.
17.1.4
Leveling the Case
It is important that the case is level. A wrench is included to aid in adjusting leg levelers. Check the left-to-right level of the
case along front of plastic air deflector retainer. Check the front-to-rear level of the case along the interior ends of the
case. Adjust the leg levelers as needed to level the case in each direction.
Cleaning: Unit must be cleaned before initial use. See full manual for instructions.
(18)
ELECTRONIC TEMPERATURE CONTROL (REFRIGERATED UNITS ONLY)
(19)
INITIAL STARTUP (REFRIGERATED UNITS ONLY)
NOTICE
This refrigerated display case is designed to operate in a maximum environment of 80 DEG. F and 55% relative
humidity. Exceeding these limits will cause poor case performance and sweating.
For more detailed information on control operation see the section “Electronic Temperature Control” in the full
manual.
(20)
PLACING PRODUCT INTO CASE
Do not exceed 150 pounds of weight per shelf. Heavy product should be distributed evenly across the entire shelving
area. Allow two inches of space behind and above stocked items.
Allow a minimum of 2” between top of product and bottom of next shelf up.
Allow refrigerated models to run for at least two hours before placing pre-chilled product into unit.
NOTICE
Risk of Electric Shock. If the cord or plug becomes damaged, replace only with a cord and plug of the same type.
(21)
CORD CONNECTED (STANDARD)
•
A factory installed power cord is properly sized to the amperage requirements of the case. See the electrical data
plate located on the rear exterior of the case for the proper circuit size for each case.
•
The cord is factory installed protruding from the rear corner of the case.
•
A separate circuit for each display case is required to prevent other appliances on the same circuit from
overloading the circuit and causing malfunction.
See full installation and operation manual on Federal
’s website by scanning the QR code:
https://federalind.com/docs/default-source/service-documents/e3980-vrss-vnss.pdf?sfvrsn=272b5266_18
NOTICE
Load items at 38°F or colder
. At time of loading, items stocked in unit
MUST
be pre-chilled. Items must be 38°F
or colder.
