E3980 VRSS
13
JOINING TRIM
6.
Replace all panels that were previously removed and re-insert honeycomb
7.4.2
Join units with glass divider, or join refrigerated to non-refrigerated
For this joining configuration, one unit will come with a lower end panel
preinstalled with glass. Five bolt holes will be exposed on the outside of this
panel and are the locations that will be used to join the units together. This kit
also comes with top and rear exterior trim, but no interior trim.
1. Remove all Shelves, display deck, interior back panel(s), exterior back(s), front
and rear base panel, and loosen honeycomb (see cleaning section for
honeycomb removal) material on the unfinished end to expose the holes used to
bolt units together.
2. Position the right or left most unit in the desired position for the lineup to start,
and level this case.
3. Push the 2
nd
case next to the 1
st
and line them up as closely as possible.
4. Adjust the leveling legs of the 2
nd
case until the bolt holes align with the mating
holes in the joining case.
5. Push the units together so that the through bolts go through the case to be
joined.
6. Using the hardware provided (1/4-20 screw, washer, lock washer), screw the 2
nd
case with the unfinished end into the first case.
