Page 15 of 39
7.3
GLASS SHELF INSTALLATION (OPTIONAL)
GLASS SHELF
SHELF STANDARD
REAR SHELF
SUPPORT
SHELF LIGHT ASSEMBLY
SHELF BRACKET
GLASS SHELF RETAINER CLIP
BACK OF CLIP ONE INCH FROM BACK OF GLASS SHELF
CORD RETAINER CLIP
PRODUCT STOP
PLACE GLASS SHELF RETAINER
CLIP OVER REAR SHELF SUPPORT
SHELF STANDARD
RETAINING SCREW
OPTIONAL BOTTOM
SECTION GLASS SHELF
CLIP LOCATED ONE INCH FROM BACK
EDGE IN FAR CORNER OF GLASS SHELF.
CLIPS FIELD INSTALLED TO GLASS.
TOP VIEW
PRODUCT STOP
1.
For first time installation attach (2) glass shelf retainer clips to each glass shelf in location shown in illustration one
inch from back of glass as shown. Clean area of glass where glass shelf holder is to be located with rubbing alcohol
and let air dry before installing shelf glass holder. Remove backing from tape located on flat side of glass shelf holder.
Position the glass shelf holders in the (2) far corners of glass. Repeat for each glass shelf.
2.
For first time installation attach (1) product stop to each glass shelf as shown in detail above. Align the product stop
edge with the edge of the glass and push the “U” portion of the product stop on to glass lip across the entire front of
glass.
3.
Attach a clear bumper on both sides of the light housing top surface for the front of the glass to set on. This step may
have already been performed at the factory for you.
4.
Place front of glass shelf onto clear bumpers on front shelf light. (On front shelf support for models without shelf
lights).
