Page 14 of 39
RIGHT
WRONG
6.
If the socket is not being used for a shelf light, the cap must be plugged into socket for entire light system to operate.
On Models with the 5 pin shelf plug, this is necessary for the entire light system to operate. On models with the 3 pin
shelf plug, this is necessary to prevent buildup and damage to the receptacle.
7.
Plug in shelf light by aligning the male pins on the appropriate shelf light cord plugs with the female light sockets and
push together. IMPORTANT: Do not roll plug during insertion.
8.
Hang one end of the shelf support on to the rear notch of one shelf bracket and then on the rear notch of the shelf
bracket on the opposite side.
9.
Place supplied shelving onto shelf supports as outlined in the appropriate “Shelf Installation” section of this manual.
10.
Removal of shelving is performed by following steps in reverse order.
11.
The shelf standards are removable from case by removing the (2) shelf standard retaining screws holding them to the
inside wall of case.
7.2
SOLID SHELF INSTALLATION
SHELF STANDARD
REAR SHELF SUPPORT
SHELF BRACKET
SHELF LIGHT CORD
RETAINER CLIP
SHELF STANDARD
RETAINING SCREW
REAR SHELF SUPPORT
SHELF LIGHT ASSEMBLY
SHELF LIGHT ASSEMBLY
TAB
SLOT
1.
Install shelf brackets & shelf supports as described in Shelf Bracket & Supports Installation Section of this manual.
2.
Place the front of metal shelf onto front shelf light. (On front shelf support for models without shelf lights). The tab on
end of shelf bracket must go through slot in front of shelf.
3.
Place the back of shelf over the back of the rear shelf support.
