Federal 204-SN8CDBLK, Инструкция по установке и эксплуатации

Страница: 6 / 26

Series ’90 Cold Deli Display
Page 6
Removing Packaging Material
Remove the brackets that held the case to the shipping skid.
Remove the plastic ties that hold the metal shelf and shelf brackets in place.
Remove the shipping tape that secures the doors and lift-up glass. If it is necessary to remove tape
residue from plastic materials, use cleaning compounds recommended in the cleaning section of this
manual.
Leveling the Case
The case must be level for proper drainage of defrost condensate to the condensate evaporator.
Four (4) leg levelers are provided for leveling the case. The leg levelers can be turned in and the
case can be placed with the base frame on the floor.
The leveled case can be sealed to the floor using an NSF Listed Sealant.
Grill Removal
The front of the case has a removable base panel to access the anti-fogging fans and the front leg
levelers from inside of the case. Normally it is not necessary to remove the panel to install the case.
This panel must be in place for proper operation of the case.
There are two (2) removable panels on the back of the case. The left side panel allows access to the
light ballasts, the pullout condensing unit, and the field wiring connection box. Remove this panel
to make field wiring connections.
The right side panel houses the thermometer, power switch, light switch, and thermostat.
Removing this panel allows access to the terminal board, branch circuit fuse (SN8CD Only), and
the condensate evaporator. Normally it is not necessary to remove this panel to install the case.
Condensate Evaporator
This case is furnished with an electric condensate evaporator. Plumbing connections are not
required.
The condensate evaporator is located behind the control panel box and is accessible from the rear
of the case.
Lights
Make certain that the light cord plugs are completely inserted into the sockets or arcing may result
causing damage to the plugs and sockets.
The ballasts used on this case allow removal of one or more shelf lights without affecting the
remaining lights.
DANGER:
Electric shock hazard. Do not operate unit with panels
removed.