Federal 204-SN8CDBLK, Инструкция по установке и эксплуатации

Страница: 12 / 26

Series ’90 Cold Deli Display
Page 12
Rear Wrapping Board
The rear wrapping board is attached to the back side of the case and can be put into a position by
swinging it up and pushing it forward. It can also be removed completely by lifting it upward off
its mounting track while the wrapping board is in the down position.
Light Replacement
The light fixtures use a spring loaded socket on one end. To remove a light, push the bulb toward
the spring-loaded socket until the opposite end drops out of the socket.
The bulbs are furnished with plastic safety light shields. Make certain the light shields are always
in place to safeguard against bulb breakage.
When replacing lights, use direct equivalents to the original bulbs.
Placing Product into Case
Do not overhang the wire shelves with product or display pans. Overhanging the shelves will block
the refrigerated air flow and could cause product loss.
Do not block the slots along the front or rear of the case display floor.
CASE SHOULD BE STOCKED WITH PRE-CHILLED PRODUCT ONLY.
The display pans are removable for
cleaning and can become dislodged in
shipment. To ensure proper air flow
and performance of the case, make sure
that the display pans are positioned as
shown. Check that the pans are installed
properly before placing product on the
display pans.
Periodic Maintenance
Cleaning Condenser Coil (Self-Contained Units)
Turn power switch off.
Remove the rear grill and vacuum the front surface of the condenser coil.
This should be done every one to two months as necessary.