58
Web Browser Activation
Series C
Federal Signal www.fedsig.com
over a LAN to transmit and receive data from siren sites using the radio modem.
SmartMsg must be enabled and the must be connected to a SmartMsg server to
enable the to communicate with other CCUs. Selecting No CCUs, the
will not respond to any other CCUs that try to communicate over the network interface.
Selecting All CCUs, allows all other CCUs with a CCU ID of 900-999 to communicate
with the . When Individual CCUs is selected, only the CCU numbers entered in
one or more of the ten slots are able to communicate with the . Enter up to ten
individual CCU IDs.
NOTES:
• When more than one is connected to a radio on the same frequency,
CCU access must be restricted to prevent a CCU from talking to two radio
modems at the same time.
• When an Hotkey Activation Button is configured with a Code#3 Hotkey,
CCU access must be restricted to prevent multiple Commander CCUs from
processing the command at the same time.
FSConnect
Use FSConnect to enable or disable FSConnect access and to select the FSConnect
environment. FSConnect must be enabled to communicate with the Federal Signal
CommanderOne® cloud server.
NOTE: The UUID, Authentication, and Encryption keys must be set to values specified
for your FSConnect environment. Contact Federal Signal Integrated Systems Technical
Support to obtain these settings.
Modbus
Use the Modbus check box to enable or disable the Modbus interface. You can change
the default port number if needed. You can use this interface in conjunction with the
SmartMsg interface, but disable the interface if not required for system operation.
After changes are made, click the Apply button, and then reboot the RTU from the Reboot
web page to begin using the new configuration settings.