56
Web Browser Activation
Series C
Federal Signal www.fedsig.com
Changing the Network Settings
You can configure the RTU to obtain an IP address automatically using DHCP and AutoIP,
or you can assign a Static IP address. Coordinate the static IP addresses with the system
Network Manager to prevent address duplication.
You cannot leave the Default Gateway blank when a static IP address is assigned. A valid
IP address is required. Use the server’s IP address as the gateway if making a direct
Ethernet connection to the device.
After changes are made, click the Apply button and reboot the RTU to begin using the
new configuration settings. Reboot the RTU by cycling power or from the Reboot web
page.
If the is configured for DHCP, use the S software program to read the
configuration to obtain the IP address. Type the IP address into your Chrome®,
Edge®, or FireFox® browser to navigate to the web page.
To change the Network Settings of the :
1. Select Network.
The Network Settings page appears.
Field
Description
Obtain an IP address
automatically
When the device is rebooted, it will obtain new network
settings automatically from the network DHCP server.
Use the following IP
address
Choose this option to supply static settings. You must enter
an IP address, Subnet mask and Gateway. A DNS server
address is only required if domain names are used instead of
IP addresses.
IP Address or
Domain Name
The RTU’s assigned IPV4 address or its domain name in the
IP address field.